Paragon F200 Lamp Working / Annealing
Kilns
This is a true high performance kiln
that you will enjoy using often. Anneal large glass figurines up
to 6” tall in the digital F-200 lamp working kiln. Raise the
spring-loaded vertical-drop door to insert a glass figurine with
a punty rod. Lower the door. The punty rod extends outside the
firing chamber through the smaller punty rod door. This allows
the glass to anneal safely. Maintain the annealing temperature
indefinitely with the Sentry Xpress 3-key
controller.
The F-200 not only fires
figurines but also safely anneals glass beads to prevent
breakage during cooling. The 2” tall, 11” wide double doors
give 22” of width for inserting bead rods. This kiln is ideal
for seminar teachers. It is like having two kilns instead of
one.
With the element in the top, you
can fuse and slump glass in this large, 25” wide x 15” deep
versatile kiln. Enjoy even heat distribution for consistent
firing results. The F-200 easily reaches fusing temperatures.
The F-200 has durable insulating
firebricks in the roof, walls and floor. The element is seated
in pinless grooves in the roof. The element is mounted in the
top of the kiln for safety. There is no sidewall element.
The insulating firebrick,
wrapped in heavy-gauge steel, soak up heat for slow, efficient
cooling. Costly heavy-gauge nickel-plated copper wiring is
covered with high temperature glass-braided insulation. The
thermocouple, which senses temperature inside the kiln, is
protected with a high-nickel stainless steel sheath for long
life. No extra stand is needed; the built-in base stays cool
even during extended hold times.
The F-200 has dual mechanical
relays for extra reliability. They send power to the elements on
command from the digital controller. Two relays last longer than
the single relay of competitive kilns because of the reduced
amperage going through the relays.
In addition, you can order the
mercury relay upgrade with your new kiln. The mercury relays
found on our large industrial kilns outlast mechanical relays.
The life of the quiet, reliable mercury relay has been measured
in millions of on/off cycles.
The F-200 has a user-friendly
3-key Sentry
Xpress 3-key controller which includes two firing modes:
Single Speed and 8-segment Ramp-Hold. The solid-state controller
continually monitors the firing so you can spend your time
productively without closely watching the kiln. The sealed
controller touch pad keeps out dust and is easy to wipe clean.